strengthen inspection of rolling groove

Tonghua Iron and Steel Group has successfully developed high-speed wire rod production HRB400E
Published :2012 -12-4
November 21 , Shougang Tonghua Iron and Steel Group through high-speed wire rod plant new lines of production HRB400E8 mm rebar 42 99.7 tons , HRB400E8 mm rebar awarded the successful development and production .
It is understood , HRB400E test  seismic reinforcement steel is rolling temperature requirements are very strict, new product development is currently under trial production stage. The production is the fourth rolling plant this year, but also the largest number of rolling , the best one, spinning temperature first drops 900 ℃, changing the spinning temperature is not lower than the previous record of 1000 ℃ for .
In the organization of production vibration measurement process, production department and rolling mill plant personnel to develop a reasonable plan rolled repeatedly revised operating points , the technical personnel at the scene to track the guidance requires workers reasonable control roller speed to ensure open rolling temperature , temperature and spinning into the finishing temperature , strengthen inspection high precision bearing of rolling groove , guide and guard the entrance , timely adjust the size of the finished wire , seismic steel products to ensure customer requirements for dimensional accuracy , quality assurance pruning to ensure end to end water cooling and defective parts are not all clean and trim so storage product quality to meet market and customer needs .
It is reported that the feedback data center sampling technique from watching the indicators uniformity , yield strength and tensile strength are up to quality requirements.

Before installing the bearings should be cleaned

High-speed precision angular contact ball bearings , mainly used for high-speed rotating occasions lighter  loads , requiring high precision bearings , high speed, low vibration and low temperature rise Hydrodynamic Bearing a certain life . Often high-speed spindle support member installed in pairs , is the inner surface grinding spindle speed key component parts .
The main technical indicators:
1 bearing precision index : Over GB/307.1-94 P4 class precision
2 high-speed performance: dmN value 1.3 ~ 1.8x 106 / min
3 life ( average ):> 1500 h
High-speed precision angular contact ball bearing service life of a great relationship with the installation , you should note the following
1 bearing installation should be clean , clean room for the bearing to be carefully matching, bearing  spacers Slewing bearing
  to go through the grind of maintaining high inner and outer ring spacers under the premise of the spacer should be controlled in parallel 1um the following ;
(2) Before installing the bearings should be cleaned , cleaning the inner slope upward , feel should be flexible , no sense of stagnation , dried , placed in a predetermined amount grease, oil mist lubrication should be placed in the case of a small amount of oil mist ;
3 bearing installation tool should be used exclusively , even by force , is strictly prohibited beat ;
4 bearing deposit should be clean and ventilated , non-corrosive gases, relative humidity less than 65% , long-term storage should be periodically rust.